Connecting Your Lumen200S To An Optiscan Or Proscan System - Prior Lumen200 User Manual

4.2.4 Connecting your Lumen 200S to an OptiScan or ProScan System
The Lumen 200S can work together with a Proscan or Optiscan controller assuming you have an
active shutter connection, see Fig 22.
1. Connect Shutter Cntlr port on the Lumen200S to the Shutter port on the ProScan or
OptiScan II system using the cables provided.
a. It is not important which shutter ports are used on the Controller, but this should be
noted for use with the command set described below, or for setting up your 3
software.
b. Switch on the Controller, your Lumen 200S is now ready to accept commands.
Lumen 200S Shutter connections
To the Lumen
200S
Fig 22 – The Lumen200S Connections
L u m e n 2 0 0 / S / P r o
To the Controller
™
OptiScan Controller Shutter connections
ProScan Controller Shutter connections
rd
party
27