Installing Your System; Installing The Bulb - Prior Lumen200 User Manual

3.2

Installing your system.

3.2.1

Installing the Bulb

Required equipment:
Lumen 200, Hex Key, Prior LM200B1-A Bulb
Warning:
• Only use Prior LM200B1-A bulbs, failure to do so may cause damage to the unit.
• Do not touch the inside of the reflector of the bulb.
• The bulb is delicate, handle with care.
Instructions:
1. Do not connect the unit to the mains supply. (If the Lumen200 has been previously switched
on, wait for 30 mins to allow bulb to cool).
2. Find a flat surface and place the Lumen200 upside down on the surface.
3. Unscrew the four Hex screws and remove the panel, as indicated in Figure 3 below.
Figure 3 - Bulb Housing.
12
Hex Screws
P r i o r S c i e n t i f i c