Installing Your System; Installing The Bulb - Prior Lumen200 User Manual

4.2

Installing your system.

4.2.1 Installing the Bulb

Required equipment:
Lumen200S, Hex Key, Prior LM200B1-A Bulb
Warning:
• Only use Prior LM200B1-A bulbs, failure to do so may cause damage to the unit.
• Do not touch the inside of the reflector of the bulb.
• The bulb is delicate, handle with care.
Instructions:
1. Disconnect the Lumen200S from the mains supply, (If the Lumen200S has been previously
switched on, wait for 30 mins to allow bulb to cool).
2. Find a flat surface and place the lumen upside down on the surface.
3. Unscrew the four Hex screws and remove the panel, as indicated in Figure 11 below.
Fig 11- Bulb housing.
L u m e n 2 0 0 / S / P r o
™
Hex Screws
19