Connecting Your Lumen200S To A Pc; Install The Usb-Com Port For Lumen200S In Windows 7 - Prior Lumen200 User Manual

5. Locate the collimating lens supplied to attach the light guide onto the microscope, loosen the
screw on the back of the collimating lens. Firmly push the light guide into the hole ensuring it
has reached it end stop and tighten the screw.
6.
The Lumen is supplied with a collimating lens specifically designed to fit your microscope, the
supplied collimating lens will only fit the specified make of microscope.
7.
The illumination can be optimized by focusing the beam by adjusting the distance between the
fibre tip and the microscope by unscrewing the collimator. The silver focus locking ring and
then be used to fix the collimator into the optimum position. (See Fig 2)

4.2.3 Connecting your Lumen200S to a PC

The Lumen200S can be controlled directly from a PC without the need of an external controller
such as an OptiScan or ProScan.
The Lumen200S will emulate a Prior Proscan controller with one shutter connected, and can be set
rd
up in 3 party software this way.
The PC can be detected via USB or RS232 cable. If the USB cable requires a driver then please go
the following section on the Prior Scientific website and download PL200/ES10ZE USB Drivers;
http://www.prior.com/downloadcentre/dc_software.html
4.2.3.1 Installing the USB-COM port for Lumen200S in Windows 7
Plug in the USB cable to the Lumen200S and the computer, power on the Lumen200S. Windows 7
should automatically recognize the device and install the appropriate drivers.
4.2.3.2 Installing the USB-COM port for Lumen200S in Windows XP
Plug in the USB cable to the Lumen200S and the computer, power on the Lumen200S.
L u m e n 2 0 0 / S / P r o
™
23