6-3-4. Trigger Signal
Trigger signal recording enables recording that uses external input connected to camera or TCP
command input as trigger of recording.
[1]Setting trigger signal
2)
4)
1) Click the [Setting] button in the main window, then select [Trigger recording settings]
tab in the Advanced setting window.
2) Select [Trigger signal] in the Event signal section.
3) Configure the recording time.
4) Select camera to receive trigger signals in the detection condition section.
→Only one camera can be selected.
5) Close the Advanced Setting window by clicking the [OK] button.
[2]Starting trigger recording
6) Select [Trigger recording] in the main window. ([Trigger signal] is shown on right side.)
7) If [REC] button is clicked, status will change to waiting trigger.
→Video is saved when trigger is detected.
The external input signal from the camera is "input 0".
Please see your camera's manual for external input signals.
For TCP command external input, Following command is send to this application.
trigger n(CR)
"OK" is returned if command is successfully received.
[3]Confirming recorded video
8) Click the [History] button in the main window and confirm
(See
7. Watching Recorded
3)
Command
Video)
Description
n:Camera No(1~8)
"0" is a recording from all cameras
(CR): Carriage return code (0x0d)
27