Kohler KD62V12 Operation And Maintenance Manual page 14

Contents
8.4
8.5
8.6
8.7
14
Standard tightening torques
8.4.1 Screws pre-tightening, reuse and marking
8.4.2 Standard torques for hexagonal / socket / flange screws
8.4.3 Standard torques for internal drive pipe plug with conical thread
8.4.4 Standard torques for locking screws and banjo bolts
8.4.5 Standard torques for metric flange joints
8.4.6 Standard torques for metric thread unions L series (up to 500 bar/7252
Psi)
8.4.7 Standard torques for metric thread unions S series (up to 800 bar/
11603 Psi)
8.4.8 Standard torques for imperial thread unions L series (up to 500 bar/
7252 Psi)
8.4.9 Standard torques for imperial thread unions S series (up to 800 bar/
11603 Psi)
8.4.10 Standard torques for metric thread unions L series (up to 500 bar/7252
Psi) for aluminum
8.4.11 Standard torques for cutting ring flange joints
8.4.12 Standard torques for triple lock flange joints
8.4.13 Standard torques for VSTI screw plugs
Abbreviations - Acronyms
Unit conversion tables
8.6.1 Length conversion factors
8.6.2 Mass conversion factors
8.6.3 Pressure conversion factors
8.6.4 Volume conversion factors
8.6.5 Power conversion factors
8.6.6 Moment of inertia and torque conversion factors
8.6.7 Fuel consumption conversion factors
8.6.8 Flow conversion factors
8.6.9 Temperature conversion factors
8.6.10 Density conversion factors
Prefix
© 2019 by Kohler Co. All rights reserved.
Operation and Maintenance Manual
KD62V12 33521030301_6_1 EN_US
159
159
161
162
163
164
164
165
166
167
167
168
169
170
173
175
175
175
175
175
176
176
176
176
176
176
178
2019-02