Turning-On; How To Make Coffee - FlyTek ZIP PRO 4 Operation And Maintenance Manual

Turn on the machine using the general switch (ref. K) located on the lower left side of the same machine; the
incorporated light turns on. At this point it is possible to decide which single components are to be turned
on: left coffee group and/or right coffee group through the relative switches (ref. E); steam and hot water
delivery boiler through the proper switch (ref. H); cup-warmer tray through the appropriate switch (ref. L).
The above-mentioned components can be turned on or off completely independently one from another.
Press one or both coffee group ON switches (ref. E); the relative lights (ref. C) light up. As soon as turned on,
the rapid heating process of the relative groups starts. Wait about 2 minutes for the coffee groups to reach
the optimal working temperature to then be ready for use.
Once passed the 2 minutes, activate one or both pod press levers (ref. F) lifting them upwards as indicated
by arrow 1. Insert a pod in one of the proper seats and delicately lower the lever until the mechanical stop
clicks, as indicated in the figure by arrow 2
Place a cup in correspondence of the coffee pouring spout (ref. B) where the pod was inserted and press
one of the two correspondent keys (single espresso or double espresso) of the relative pushbutton panel
(ref. D). For example, if you want to obtain a single espresso using pourer B1, you must press the 0 key of the
left pushbutton panel:

TURNING-ON

HOW TO MAKE COFFEE

0 2 4
1 3
B1 B2
1
2
5 7 9
6 8
B3
B4
18