Installing Acp - LG PQCPA11A0E Installation & Owner's Manual

2. Installing ACP

This chapter describes how to install the ACP to use.
Caution: Installing the ACP
The ACP installation work needs the professional technique. Therefore, the
installation described at this chapter should be performed by the certified
installation professional.
Consult the service center or the professional installation agency certified by us about
any question or request related to the installation.
In order to use the ACP, the environment for the ACP, the indoor unit and the ventilator to
communicate should be built and the indoor unit should be registered.
In order to use the ACP, the installation should be performed by the following order.
STEP 1. Check the environment before installing the ACP
Before installing the ACP, check the network configuration according to the
interconnection between the ACP and the external device.
STEP 2. Set the indoor unit address and Connecting the PI485
Set the address of the ACP not overlapped with the connecting indoor unit and connect
the PI485.
STEP 3. Install the ACP and set the environment and the function
Install the ACP and set the network environment and the function.
STEP 4. ACCS access and Information input
Set the access environment at the LG ACCS, the ACP operation program and enter the
air conditioner information.
STEP 5. Make sure and check the ACP installation
Make sure and check that the ACP is normally installed.
Installation/Owner's Manual
2. Installing ACP
2-1