Configuring the ACP network
After connecting the ACP to various devices via the cable, the network environment of the ACP should
be set by driving the ACP. The following information should be set for using the ACP.
• IP address of the ACP
• Gateway address
• Net mask address
Caution: Setting the network environment information
If the above information is not entered, the communication error may be occurred or it
may be impossible to control by the ACP. So, be careful to correctly input.
Beforing configuring the ACP environment
The network environment of the ACP can be set by the LCD and the buttons at the front side of the ACP.
The current ACP information and the menu are displayed at the LCD, and the menu can be changed
and selected by pressing 'MENU/SELECT' button and Up/Down/Left/Right (▲, ▼, ◀, ▶) buttons.
1
DI
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
MENU/
SELECT
18
19
20
1
DO
2
3
4
TX
LG-NET 1
RX
TX
LG-NET 2
RX
TX
LG-NET 3
RX
TX
LG-NET 4
RX
TX
FDD
RX
TX
Ext.
RX
ACT
Ethernet 1
LNK
ACT
Ethernet 2
LNK
TX
Console
RX
Run
Power
MENU/
SELECT
Installation/Owner's Manual
2. Installing ACP
2-25