Page 1
Installation work must be performed in accordance with the national wiring standards by authorized personnel only. Please retain this installation manual for future reference after reading it thoroughly. TYPE : (Dry contact for demand control) MODELS : PQDSBCDVM0 www.lg.com P/NO : MFL42540239...
SAFETY PRECAUTIONS SAFETY PRECAU- NAME OF EACH PART TIONS To prevent injury to the user or other people and property damage, the following instruc- tions must be followed. • Incorrect operation due to ignoring instruction will cause harm or damage. The seriousness is classified by the following indications.
Multi-V After change any Dry contact setting, then you must press RESET switch to reflect the setting. ODU Dry contact BRACKET (1EA) PQDSBCDVM0 Multi-V Power source input ① When wiring power source from outdoor SCREW (4EA) WIRE ASSY 1(1EA) unit.
Page 4
SETTING AND USING METHOD When outdoor unit doesn’t have RS- 485 communication function (Slave Mode) SW_VOLT2 SW_VOLT1 Multi-V WIRE ASSY 1(1EA) LG does not supply this section SW_VOLT2 SW_VOLT1 (Field supply) CN_OUT TTL DC 0~10V input SW_VOLT2 SW_VOLT1 Direct Digital Controller...
Page 5
SETTING AND USING METHOD Setting of SWDIP and SW_STEP - Type of input signal SW_STEP Input Signal ② 0, 1, 2, 3, 4, 5, 6 Contact signal input ① Analog input signal * Detail of the control step for contact signal L1 2 3 4 input.
Page 6
SETTING AND USING METHOD NOTE - Using this switch, the address of out- door unit can be set as 0~254(00~FE) - If the outdoor unit has it’s own address, you need not to set address in slave mode. - After change ‘SW_Adress’ setting, then you must press reset switch to reflect the setting.
Page 7
Representative: LG Electronics Inc. EU Representative, Krijgsman 1, 1186 DM Amstelveen, The Netherlands Manufacturer: LG Electronics Inc. Changwon 2nd factory, 84, Wanam-ro, Seongsan-gu, Changwon-si, Gyeongsangnam-do, KOREA...