LG PQCPA11A0E Installation & Owner's Manual page 24

2. Installing ACP
Setting address with wireless remote controller
ON OFF
SET CANCEL
2-10
ACP
PLASMA
You can set the address of the indoor unit through the
wireless remote controller that controls the indoor
unit. To set the address of the indoor unit with the
wireless remote controller, proceed as follows.
1. With the [Power Cool] button pressed, press the
[RESET] button. The [Power Cool] button must be
pressed for more than 3 seconds.
2. Use the [Temperature Adjustment] button to set the
address of the indoor unit.
Temperature
adjustment
3. After setting the address, press the [Operate/Stop]
button once toward the indoor unit.
4. When the set address is displayed on the indoor
unit, the address setting is complete.
Reference: Address display time and method
The address display time and method may differ
by the type of the indoor unit.
5. When you reset the remote controller, it switches
from the address setting mode to general operation
mode.
Reference: Type of remote controller
When using a different type of remote controller
from the one described above, refer to the user
manual of the applicable remote controller.
Group No.
Indoor unit No.