2. Installing ACP
Setting the gateway address
After setting the IP address, the gateway address should be set. Set the gateway address as follows:
1.
Press the 'MENU/SELECT' button of the ACP and then press Left/Right (◀,▶) button to display
the following Gateway setup screen. Press the 'MENU/SELECT' button again. The screen to enter
the gateway address is displayed.
MENU/
SELECT
2.
Use Up/Down/Left/Right (▲,▼,◀,▶) button to enter the desired gateway address.
MENU/
SELECT
3.
After entering the gateway address, press the 'MENU/SELECT' button to set the entered gateway
address. But, there is no 'MENU/SELECT' button pressed for a specific period (about 5 seconds), it
returns to the initial screen with the entered gateway address not applied to the system, and the
existing set gateway address is used.
MENU/
SELECT
2-30
ACP
Click
MENU
/SELECT
button
Example to set Gateway address
[MENU]
Set GW Address
[Set GW Address]
192.168.000.000
[Set GW Address]
165.186.002.001
ACP
SW ver. 2.77.2