Rear Panel - Fagor Innova 40i TS Installation & Operation Manual

3.3

Rear panel

On the back of the unit the following items may be found:
* Three-prong power connector for AC and ground connection.
* M6 mm terminal, for general machine ground connection.
* Mounting bracket.
* Feedback connectors:
X1.-SUB-D HD type 15-pin female connector for 1st axis feedback device.
X2.-SUB-D HD type 15-pin female connector for 2nd axis feedback device.
X3.-SUB-D HD type 15-pin female connector for the third axis feedback device.
X4.-SUB-D HD type 15-pin female connector for 4th axis (spindle) feedback device.
* 37-pin connector for inputs and outputs.
*USB connector.
In order to comply with UL standards, this unit must be connected in the final application using a
UL
listed detachable cord set (BLEZ) with a molded three-prong plug and a suitable fitting to be
seal
connected to the equipment, rated minimum 300 V AC. The cord type shall be SO, SJO or STO.
Suitable Strain Relief means must be provided in the cord set to assure the connection of the plug
and the fitting.
ETL file number:
WARNING
Do not handle the connectors while the unit is under power.
Before handling the connectors (mains, feedback, etc.) make sure that the unit is not under power.
It is NOT enough to turn the display off by using the [on/off] key at the keyboard
40i TS - v1205 - Installation/Operation - (13/29)