Function "Simulation" (065) - Endress+Hauser levelflex M FMP 40 Manual

8 Function group "output" (06), - "profibus param." (06), PROFIBUS-PA only
⇒
52

8.11 Function "simulation" (065)

If necessary, linearisation, the output signal and the current output can be tested with
the simulation function. You have the following simulation options:
Selection:
• sim. off
• sim. level
• sim. volume
• sim. current (HART only)
sim. off
Simulation is switched off.
sim. level
Enter the level value in "simulation value" (066).
The functions
• measured value (000)
• measured level (0A6)
• output current" (067) - only with HART instruments!
follow the entered values.
sim. volume
Enter the volume value in "simulation value" (066).
The functions
• measured value (000)
• output current" (067) - only with HART instruments!
follow the entered values.
sim. current (HART only)
Enter the current value in "simulation value" (066).
The function
• output current" (067) - only with HART instruments!
follows the entered values.
Levelflex M
Endress+Hauser