Function "Probe Length" (031); Function "Probe" (032); Function "Probe Length" (033); Function "Determine Length" (034) - Endress+Hauser levelflex M FMP 40 Manual

Levelflex M
⇒
!
⇒
⇒
⇒
Endress+Hauser
3.6

Function "probe length" (031)

Use this function to select whether the probe length was changed after factory calibra-
tion. Only then is it necessary to enter or correct the probe length.
Selection:
• not modified
• modified
Note!
If "modified" was selected in the "probe length" (031) function, the probe length is defi-
ned in the next step.
3.7

Function "probe" (032)

Use this function to select whether the probe is uncovered or covered.
If the probe is uncovered, the Levelflex can determine the probe length automatically
"determine length" (034). function. If the probe is covered, a correct entry is required
in the "probe length" (033) function
Selection:
• free
• covered
3.8

Function "probe length" (033)

With this function, the probe length can be entered manually.
3.9

Function "determine length" (034)

Use this function to determine the probe length automatically.
Selection:
• length ok
• too short
• too long
3 Function group "basic setup" (00)
19