Toshiba teli BU1207MG Instruction Manual page 25

- Line2 (GPIO Input / Output, initial factory setting: Input, I/O connector : 1 pin)
Input / Output specification
Factory setting
- Input signal specification
Level
Polarity
Pulse Width
Notes of external trigger signal:
Depending on cable length, cable kinds and input current of trigger input line, Random Trigger Shutter operation may not
satisfy timing specification or camera may not receive EXT_TRIG signal. Please confirm it before use.
Notes of input level:
Line0 and Line2 have different input level. Please use input level within the voltage described in this specification.
- Output signal specification
Output Circuit
Maximum Current : +/-32mA
Polarity
Signal Source
*Even if LineMode is set as Output, the input signal to Line2 is valid when LineSource is set as Off.
Input / Output circuit diagram
Copyright © 2020 Toshiba Teli Corporation, All rights reserved.
: Input / Output (switch by LineMode is possible)
: Output
: Low 0 ~ 0.5V, High 4.0 ~ 5.0V
: High active / Low active (initial factory setting: Low active)
: Minimum 50μs
: 5V CMOS
: High active / Low active (initial factory setting: Low active)
: Off* / UserOutput / Timer0Active / AcquisitionActive
FrameTriggerWait / FrameActive / FrameTransferActive
ExposureActive
IOLineModeAll
Inside
DC5.0V
10kΩ
24 / 161
1
3
D4279014C
http://www.toshiba-teli.co.jp/en/index.htm