Table of Contents
Advertisement
ATTENTION
Installation, disassembly and setting should be carried out by qualified technical personnel
only.
If traces of coffee are found, this is consequent to testing operations performed in the factory.
NOTICE FOR THE SERVICEMAN
1. Carefully read the instruction herein, which contain important information for safe installation, use and maintenance. Keep this
booklet on hand for further reference.
2. This appliance shall only be used for its specific purpose. The manufacturers shall not be liable for damages due to improper,
wrong or unreasonable use.
People (children included) with reduced physical, mental, and sensorial capabilities must not operate this machine. People
with little experience or training must not use this machine unless assisted by someone responsible for their safety who can
teach them how to use the machine and can also supervise them in the process.
Keep the machine out of the reach of children and never allow unsupervised children near the machine to prevent them from
playing with it.
3. Unpack and check machine for soundness. Do not leave packaging components (plastic bags, expanded polystyrene, nails,
etc.) within children's reach, as they represent potential hazards.
4. Prior to plugging in, check that nameplate data correspond with those of the electric and water mains.
5. The coffee machine should be placed on a stable flat surface with the bodywork at a minimum distance of 1 inch (20 mm) from
the supporting surface and the walls. Furthermore, it must be installed taking into account that the highest shelf (cup warmer)
must sit at a height that is at least 47 inches (1.2 meters).
Room temperature must range between 32 and 89.6°F (0÷32°C).
6. The (electricity and water) supply connections and a water outlet fitted with a siphon should be close to the machine. A support
surface should also be available for accessories.
7. During the installation process, make sure you use a switch device that ensures that the machine is disconnected from the
supply mains with a switch-contact gap that permits complete disconnection in a Category III Overvoltage situation and protection
from leakage current equal to 30 mA. This switch device must exist on the supply mains according to installation rules.
8. This appliance is electrically safe only when properly earthed as set forth in the current electric safety specifications. Check
for compliance and, when in doubt, have the wiring thorougly inspected by skilled personnel. The manufacturers shall not be
liable for any damage caused by faulty earting.
9. Using adapters, multiple plugs and cable extensions is not recommended. Should they be indispensable, use simple or multiple
adapters and extensions that comply with the current safety regulations, take care not to exceed the limit current load shown
on simple adapters and extensions, and the limit power load shown on multiple adapters.
10. To prevent dangerous overheating, uncoil the power cable to its full length.
11. If the power cable is damaged, it must be replaced by the manufacturer or its technical assistance service or other similarly
qualified persons.
12. The device is for internal use only.
To ensure correct operation and safety, the appliance should not be exposed to outdoor weather conditions (rain, sun, ice).
13. The device is not suitable for installation in areas where jets of water can be used.
14. Do not plug or clog the ventilation and heat-exhausting louvres.
15. If the machine is stored on premises where the temperature may drop below freezing point, always empty the boiler and the
water circulation pipes
Installation
5
Advertisement
Table of Contents
