Table of Contents
Advertisement
hot WatEr: GEnEraL inStrUctionS
Place the appropriate container under the hot water dispenser
(14)
Dispensing with automatic dosing
Press one of the hot water dispending keys (12) corresponding
to the desired dose.
The programmed dose of hot water will pour from the dispenser
(14) and will stop automatically.
n.B. dispensing may be stopped by pressing the hoT WaTeR
sToP key (35) or the (12) key.
Pressing the hoT WaTeR sToP key (35) does not change
the parameters set during the programming phase.
StEam: GEnEraL inStrUctionS
fully immerse the steam dispenser tube (15) into the vessel
containing the beverage that needs to be heated.
Dispensing through the tap (13)
Turn the steam tap knob.
Wait until the beverage has reached the required
temperature.
Stop the steam dispenser by turning the knob of the steam tap
in the opposite direction.
note: at the conclusion of each steam dispensing phase, clean
the inside of the steam nozzle as follows:
Turn the nozzle towards the cup tray and carefully activate
steam dispensing at least once.
Dispensing with the turbosteam selector (45) (when
provided)
Machines equipped with the TURBosTeaM (sToP sTeaM)
dispensing system have the "stop steam dispensing when
set temperature is reached" function, and can rapidly heat
and froth milk.
select the type of milk you desire:
- using the buttons a (frothed) or B (hot).
When the set temperature is reached, steam dispensing can
be stopped:
- automatically;
- manually, pressing buttons a or B again.
for more information on the function, please consult the
engineer's manual.
3.4 Dispensing of beverages - hot water / steam
12
35
14
A frothed milk
14
13
15
45
15a
B hot milk
Advertisement
Table of Contents
