Table of Contents
Advertisement
for correct application of the haccp system,
please follow the instructions in this paragraph.
miLK circUit anD coffEE circUit cLEaninG cYcLES
The purpose of the flushing cycle is to remove all traces of
grease and scaling deposited when the milk is conveyed and
emulsified and when the coffee is dispensed.
failure to flush out the circuit will allow these deposits to
solidify. This will impair the qualitative performance of the
cappuccino maker (1) and of the coffee circuit.
notE: the following operations must be carried out when
the machine is on and pressurized.
attEntion, riSK of ScaLDinG: hot water, steam
and milk residues will spill out when the spouts of the
cappuccino maker/dispenser spout (1) are flushed. Keep
the hands and all other parts of the body well away until
the cleaning cycle has terminated.
miLK circUit anD coffEE circUit WaShinG cYcLES
The milk circuit and the coffee circuit can undergo several
types of washing cycles:
Daily wash cycle at set hour
function - The message "EXECUTE WASHING MILK
CIRCUIT" in alternation "EXECUTE WASHING GROUP"
appears on the display at the set hour (consult the "Customer
programming - service time menu" paragraph).
activation - Milk circuit: with the modalities described in
"MILK CIRCUIT WASH WITH LIqUId dETERGENT". The
message "MILK WASHING" appears on the display.
Coffee circuit: with the modalities described in "GROUP
WASH WITH dETERGENT TABLET". The message
"GROUP WASHING" appears on the display.
Selection block - milk circuit: 60' function from the hour
set if wash cycle has not taken place, with the "Block milk
circuit" function set (Yes).
Coffee circuit: 60' (30' if short washing) from the hour set
if wash cycle has not taken place, with the "Block coffee
circuit" function set (Yes).
Wash type - Milk circuit: with water and steam, and with an
external detergent in the place of the milk.
Coffee circuit: with detergent tablet inserted in the
decaffeinated coffee panel (18).
Preset automatic washing cycle
Only for machines with the cappuccino maker and gear pump
function - after each milk cycle has terminated, the timer
count-down starts (max 210'). at the end, "AUTOMATIC
WASHING" appears on the display, with the time remaining
before the wash cycle begins.
activation - activation is automatic at the end of the
remaining 30" seconds. during this stand-by time:
if the coffee dispensing key is pressed, the timer count-
down will start again from 30" seconds before the end of
the dispensing cycle;
if the milk/cappuccino dispensing key is pressed, the timer
count-down will start from the set up time (210').
If the (28) key is pressed, the automatic wash cycle will be
performed immediately.
4. cleaning operations
Selection block - always inactive. The wash cycle is
performed even if the user does not intervene.
Wash type - with milk or water, completely automatic.
Special conditions
1) with each washing cycle with detergent (at a preset time)
or daily washing cycle:
In this case, the entire circuit is washed. Therefore, during
the first milk dispensing procedure, the circuit is considered
free of residual milk and the timer (210') countdown is not
launched.
2) each time the machine is switched off while the timer
countdown (210') is underway:
when the machine is switched on again, if 210' have passed,
once the machine reaches its operating temperature, the
preset automatic washing cycle is launched and cannot be
stopped.
15
18
26
28
1
Advertisement
Table of Contents
