Table of Contents
Advertisement
2. Installation Rules
technicians.
Carefully read the warnings and rules in this manual because they provide important information regarding
Keep this booklet handy for easy reference.
After removing the machine from its packing materials, make sure that the machine and its safety devices are intact.
Packing materials (plastic bags, polystyrene foam, staples, etc.) must be kept out of the reach of children because they are
potentially hazardous.
Before plugging in the machine, make sure that the information on the nameplate (voltage, etc.) matches that of the electrical
and water systems.
Completely unwind the power supply cable.
highest surface on the machine (the cup warmer tray) sits at a height of at least 1.2 meters. Make sure there is a shelf nearby
for accessories.
Room temperature must range between 10° and 32°C (50°F and 90°F).
An electrical outlet, water connections, and a drain with siphon must be in the immediate vicinity.
Do not install in rooms (kitchens) that are cleaned with jets of water.
Do not clean the machine with jets of water.
Do not obstruct openings or ventilation and heat vents.
Do not install the machine outdoors.
3. Electrical Installation Rules
Prior to installation, make sure there is a circuit breaker installed with a distance between the contacts that allows for complete
disconnection when there is a category III overload and that provides protection against current leakage equal to 30 mA. The
circuit breaker must be installed on the power supply in compliance with installation rules.
electrician inspect the system. The manufacturer cannot be held responsible for any damage caused by the lack of an earthing
system on the electrical supply.
It is unadvisable to use adaptors, multiple plugs, and/or extension cords. If their use is indispensible, only use simple or multiple
adaptor plugs and extension cords that are in compliance with safety laws. Make sure these devices do not exceed the voltage
capacity marked on the simple adaptor and on extension cords, and the maximum voltage marked on the multiple adaptor.
Check that the type of connection and voltage correspond with the information on the nameplate: see
For machines with a Y connection: see
For machines with a
connection: see
For machines with a single-phase connection: see
WARNING
.
.
.
27
.
Advertisement
Table of Contents
