Idrac Port Card (Optional); Removing The Optional Idrac Port Card - Dell E33S001 Owner's Manual

Steps
1 Install a the SD vFlash card by inserting the contact-pin end of the SD vFlash card into the SD vFlash card slot on the module.
NOTE: The slot is keyed to ensure correct insertion of the SD vFlash card.
2 Press the SD vFlash card inward to lock it into the SD vFlash card slot.
Figure 59. Installing an optional SD vFlash card

iDRAC port card (optional)

The iDRAC port card consists of a SD vFlash card slot and an iDRAC port. The iDRAC port card is used for advanced management of the
system. An SD vFlash card is a Secure Digital (SD) card that plugs into the SD vFlash card slot in the system. It provides persistent on-
demand local storage and a custom deployment environment that allows automation of server configuration, scripts, and imaging. It
emulates USB device(s). For more information, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/esmmanuals.
The iDRAC port card consists of the SD vFlash card slot and an iDRAC port. The iDRAC port card features a dedicated NIC port and is
used for remote, advanced management of the system through the network.
An SD vFlash card is a Secure Digital (SD) card that plugs into the SD vFlash card slot in the iDRAC port card. It provides persistent on-
demand local storage and a custom deployment environment that enables automation of server configuration, scripts, and imaging. It
emulates a USB device. For more information, see the Integrated Dell Remote Access Controller User's Guide at Dell.com/idracmanuals.

Removing the optional iDRAC port card

Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Follow the safety guidelines listed in the Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
4 If connected, disconnect the network cable from the iDRAC port card.
5 Remove the cooling shroud.
Steps
1 Loosen the screw securing the iDRAC port card holder to the system board.
2 Pull the iDRAC port card to disengage it from the iDRAC port card connector on the system board, and remove the card from the
chassis.
102 Installing and removing system components