Astoria 1GR Use And Maintenance Manual page 34

The level window is replaced with a green indi-
cator light (2) in some versions: when lit, it indi-
cates the correct water level in the heating unit
and when it flashes slowly, it indicates that the water is
being loaded.
If there is no water (first installation or after heating unit
maintenance), the heating unit must be filled in advance in
order to prevent the heating element from overheating.
6.6.1 Electric heating
(versions without Display)
Depending on whether a switch or power switch is installed
on the machine, proceed as indicated in the below-indicated
specific procedure:
SWITCH
• Open the water mains valve.
• Turn the switch to the manual fill function (2) and fill the
heating unit with water until the optimal level is restored.
• Turn the switch to position "1" and wait for the machine to
warm up completely.
POWER SWITCH
• Open the water mains valve.
• Turn the power switch to position "1" (elec-
tricity is supplied to the pump to automati-
cally fill up the appliance's heating unit and
steam heating unit) and wait for the heating
unit to be automatically filled with water.
• Turn the main switch to position "2" (full electricity is sup-
plied, including to the heating element in the heating
unit) and wait for the machine to warm up completely.
36 108
of
1
2
0
1
2
0
1 2
6.6.2 Electric heating
(versions with a Display)
• Press the machine's main switch (1).
1
• Wait for the heating unit to be automatically filled with
water, if necessary.
• Wait another second or so for the automatic test to be
carried out.
FUNCTIONAL TEST
TEST RESULTS
• The machine is ready for use when the following mes-
sages appear on the display:
1.0 BAR
09:16
Heating unit Heating unit
pressure temperature
1.0 BAR
09:16 09-10-12 5
Time
See the days of the week reference table in
paragraph "Programming a Working Day" on
page 44.
If the temperature inside the heating unit is
lower than 90°C (machine's heating-up phase),
the message LOW will appear on the display.
To restart the machine, press and hold the same buttons
for 3 seconds.
WAIT
- OK -
120°C
09-10-12 5
Programming
indicator
120°C P
Date Day of the
week:
TECHNICIANS' manual