Parameter Clear - Mitsubishi Electric FR-F 700 EC Instruction Manual

4.8 Parameter clear

POINT
· Set "1" in Pr. CL parameter clear to initialize all parameters. (Parameters are not cleared when "1" is set in Pr.
77Parameter write selection. In addition, calibration parameters are not cleared.)
· Refer to the extended parameter list on page 107 for parameters to be cleared with this operation.
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
Turn until "
appears.
5.
Press
" "(initial value) appears.
6.
Turn to change it to
the setting value " ".
7.
Press
and
The inverter is not in the PU operation mode.
1. Press
2. Carry out operation from step 6 again.
Operation
to choose the PU operation
to choose the parameter

" (parameter clear)

to read the currently set value.
to set.
· Turn to read another parameter.
· Press to show the setting again.
· Press twice to show the next parameter.
are displayed alternately ... Why?
.
is lit and the monitor (4 digit LED) displays "0" (Pr. 79 = "0" (initial value)).
Display
PU indication is lit.
The parameter
number read
previously appears.
Flicker ··· Parameter setting complete!!
Parameter clear
57
4 4