Use The Setting Dial Like A Potentiometer To Perform Operation - Mitsubishi Electric FR-F 700 EC Instruction Manual

Start/stop from the operation panel (PU
operation mode)
3.4.2

Use the setting dial like a potentiometer to perform operation.

POINT
Set "0" (extended mode parameter valid) in Pr. 160 User group read selection.
Set "1" (setting dial potentiometer mode) in Pr. 161 Frequency setting/key lock operation selection.
Operation example Change the frequency from 0Hz to 50Hz during operation
1.
Screen at powering on
The monitor display appears.
2.
Press
mode.
3.
Press
setting mode.
4.
Turn until
5.
Press
" " (initial value) appears.
6.
Turn to change it to
the setting value "
7.
Press
8.
Change Pr. 161 to the setting value of "
in the similar manner. (Refer to step 4 to 7.)
9.
Mode/monitor check
Press
monitor/frequency monitor.
10.
Press
11.
Turn
The flickering frequency is the set frequency.
You need not press
REMARKS
· If flickering "50.00" turns to "0.0", the Pr. 161 Frequency setting/key lock operation selection setting may not be "1".
· Independently of whether the inverter is running or at a stop, the frequency can be set by merely turning
34
Operation
to choose the PU operation
to choose the parameter
(Pr. 160) appears.
to read the currently set value.
".
to set.
twice to choose
(or ) to start the inverter.
until "50.00" appears.
.
Display
PU indication is lit.
Flicker ··· Parameter setting complete!!
"
Flicker ··· Parameter setting complete!!
The frequency flickers for about 5s.
The parameter number
previously read appears.
.