Table of Contents
Advertisement
Operation
1.
Screen at powering on
The monitor display appears.
2.
Press
to choose the PU operation
mode.
3.
Press
to choose the parameter
setting mode.
4.
Turn
until
appears.
5.
Press
to read the currently set value.
"
"(initial value) appears.
6.
Turn
to change it to the set
value "
".
7.
Press
to set.
8.
Perform normal operation.
When you want to check the energy saving effect,
refer to the instruction manual applied to
check the energy saving effect monitor.
REMARKS
If the motor decelerates to stop, the deceleration time may be longer than the set time. Since overvoltage tends to occur as
compared to the constant torque characteristics, set a longer deceleration time.
(Pr. 60)
Flicker ··· Parameter setting complete!!
· By turning
, you can read another parameter.
· Press
to show the setting again.
· Press
twice to show the next parameter.
Energy saving operation (Pr. 60)
Display
PU indication is lit.
The parameter
number previously
read appears.
4
55
Advertisement
Table of Contents
