Advanced operation
(*) Select Auto only when the SDI mode is present in the SDI video payload identifier.
To select the 4K SDI mode
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the 4K SDI mode submenu.
4. Select one of the available 4K SDI modes and confirm.
5.3.4 SDI config (only for MDSC-8255 12G)
About SDI config
The available SDI config modes for your display are:
•
Quad-SDI (Quad link 3G-SDI)
•
Dual SDI (Dual input: SDI 1 up to 12G-SDI, SDI 3 up to 3G-SDI)
•
Single SDI-1 (up to 12G-SDI)
•
Single SDI-3 (up to 12G-SDI)
To select the SDI config mode
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the SDI config submenu.
4. Select one of the available SDI config modes and confirm.
SDI loopthrough (not available in Quad link)
SDI 2: loopthrough of SDI 1
SDI 4: loopthrough of SDI 3
5.3.5 Auto search
About auto search
By enabling the input selection auto search function, the display will automatically detect the connected
source and display it on the screen.
To enable/disable auto search
1. Bring up the OSD main menu.
2. Navigate to the Input Select menu.
3. Enter the Auto search submenu.
4. Enable/Disable auto search as desired and confirm.
5.3.6 Failover input (MDSC-8255 LED & MNA)
About failover input
This function allows the display to automatically switch to a failover (backup) source in case the main source
(DisplayPort, HDMI, Nexxis) is missing. The display will automatically restore the main source once the signal
is back.
The available failover inputs for your display are:
•
None
•
DVI
•
SDI
40
R5913964 /00
MDSC-8255