Table 2-2 Raid Card Components; Figure 2-1 Smart Array 6402 Raid Card (Sa 6404 Raid Card Not Shown) - HP Integrity rx2600 Upgrade Manual

Step 6. Install the Install the Smart Array 6402 or 6404 card.

Figure 2-1 Smart Array 6402 RAID Card (SA 6404 RAID Card not shown)

The following table lists the RAID card components.
Table 2-2 RAID Card Components
Item
ID
1 Internal SCSI connector, port A1
2 Internal SCSI connector, port A2
3 External SCSI connector, port A1
4 External SCSI connector, port A2
5 Controller battery
6 Battery-backed cache module
7 Connector for expansion board
Step 7. Slide the RAID card edge-connector into the slot until it is fully seated.
Step 8. Route the new SCSI cable(s) from the internal disks to the Smart Array card and connect the
cables.
a. For simplex mode, connect SCSI cable A7231-63024 to connector A1 on the RAID card. Do not
connect any other SCSI cables.
b. Leave connector A-2 available for external connections.
Step 9. Replace the PCI card cage and top cover and power up the system.
Chapter 2
RAID - Smart Array 6402 or 6404 Controller for Internal RAID Installation
Description
Smart Array 6402 RAID or 6404 RAID Cards
63