System Validation And Reconfiguration Procedures After Hardware Upgrade From Rx2600 - HP Integrity rx2600 Upgrade Manual

HP Integrity rx2620 Upgrade

System Validation and Reconfiguration Procedures After Hardware Upgrade from rx2600

System Validation and Reconfiguration Procedures After Hardware
Upgrade from rx2600
The system board upgrade part is configured at the factory with default product, serial and UUID IDs. After
replacing the system board, factory default ID values must be overwritten with actual system values. In
rx2600 machines, the product, serial and UUID actual ID values are stored in both the system and display
boards. Product, serial and UUID IDs can be automatically copied from the display board to overwrite the
default factory ID values on the new system board.
Step 1. Power on the system.
a. Reconnect AC power to rear panel connectors.
b. Press the front panel power switch to power on the server.
Step 2. Restore the product, serial and UUID IDs.
a. Answer Yes to the copy prompt displayed during system power on.
b. Reboot the server.
Step 3. Boot the machine to EFI.
Step 4. Verify system board installation.
a. Enter the info sys command. Verify that the newly installed system board is recognized by the
system. Below is an example of the info sys command output following a successful upgrade:
NOTE
SYSTEM INFORMATION
Date/Time:
Manufacturer:
Product Name:
Product Number:
Serial Number:
UUID: 162D4BA1-4D67-11D8-881B-E20562B8C81F
System Bus Frequency:
Step 5. Verify CPU installation.
a. Enter the info cpu command. Verify that all newly installed processors are recognized by the
system. Below is an example of the info cpu command output following a successful upgrade:
NOTE
PROCESSOR MODULE INFORMATION
CPU
Module
------
0
Step 6. Check the system event log for erroneous system events and run system diagnostics as necessary.
Step 7. Boot the operating system.
58
The product number is now rx2620 and the product, serial and UUID number
values are populated.
Aug 3, 2004 15:34:26
hp
server rx2620
AB459A
SGH4414201
199 MHz
One processor is installed in the example below.
# of L3
Logical Cache
CPUs Speed Size
------- -------- ------
1 1.3 GHz 3 MB
(20:04:08:03:15:34:26)
L4 Family/
Cache Model
Size (hex.) Rev
------ ------- ---
None 1F/02
Processor
State
------------
A1 Active
Chapter 1