HP Integrity rx2600 Upgrade Manual page 66

RAID - Smart Array 6402 or 6404 Controller for Internal RAID Installation
Smart Array 6402 RAID or 6404 RAID Cards
Step 3. At the recovery shell prompt, enter:
loadfile -l INSTCMDS /opt/raidsa/bin/ciss_insf
# loadfile -l INSTCMDS /opt/raidsa/bin/ciss_insf
Step 4. Verify that the device file for the Smart Array 6402 Card, or the Smart Array 6404 Card has been
created. At the next prompt, enter:
/opt/raidsa/bin/ciss_insf
Step 5.
NOTE
# /opt/raidsa/bin/ciss_insf
Installing special file for Smart Array 6402
/dev/ciss3 installed
Step 6. At the prompt enter:
loadfile -l INSTCMDS /opt/raidsa/bin/saconfig
# loadfile -l INSTCMDS /opt/raidsa/bin/saconfig
Step 7. Configure the array(s) and logical drive(s) following the instructions for the saconfig configuration
utility. You must enter the entire path /opt/raidsa/bin/saconfig /dev/cissX for saconfig to
run.
Step 8. Once you configure the logical drive(s) and array(s), exit the recovery shell by entering reboot at
the prompt. The system reboots and you are returned to the Boot Console Handler (BCH) prompt.
Step 9. At the BCH prompt, start Ignite-UX from the HP-UX 11i v1 or HP-UX 11i v2 Core OS Install and
Recovery Media. The Ignite-UX Welcome screen displays (see Step 1).
Step 10. Choose Install HP-UX.
Step 11. Choose the Advanced installation option.
The installation starts, and the Ignite-UX graphical interface (GUI) launches.
Step 12. Under the Basic tab, select the configuration to use HP-UX system.
Step 13. Select the Smart Array 6402, or Smart Array 6404 logical drive on which you want to install the
HP-UX operating system.
66
The following example is for the Smart Array 6402 Card. The Smart Array 6404
Card has more devices that what is shown for the 6402 card.
Chapter 2