Advertisement
Table of Contents
- 1 Ipad Podium
- 2 Feed Figure-8 Head of Power Lead through Base
- 3 Position Black Mains Cable into Internal Post Channel
- 4 Loosely Insert 2 Screws through Aligned Diametrically Opposite Holes
- 5 Lift Fascia out of Enclosure. Insert Cable
- 6 Align Holes of the Ipad Holder to the Post Fixings
- 7 Replace Fascia and Depress Lock Button to Secure Enclosure
- Download this manual
Advertisement
Table of Contents
Related Manuals for Displays2go IPDTBL
Summary of Contents for Displays2go IPDTBL
- Page 1 IPDTBL Assembly Instructions...
- Page 2 iPad Podium WARNING – large base plate is heavy (7.5kg). Carefully position base plate over 8-way post and align 4 off fixing holes to threads of post (ensuring the countersunk holes are uppermost). Insert and tighten 4 off base plate screws to secure.
- Page 3 Stand base and post upright ensuring lead is kept clear of foot pads. Plug figure-8 head into USB Power Adapter (supplied with Apple iPad). Feed figure-8 head of power lead through base until it protrudes from top of post.
- Page 4 Position black mains cable into internal post channel and carefully slide USB Align 4 holes of aluminium plate and Power Adapter down below the top of the post. acrylic podium top, with countersunk holes uppermost, with threaded holes in post...
- Page 5 Loosely Insert 2 screws through aligned diametrically opposite holes. Fully tighten 1 screw using hex key provided before removing second screw. Unlock the iPad enclosure by inserting key into security lock and rotate ‘QUARTER TURN ONLY’ clockwise or counter-clockwise through 90 degrees If you are not using cable which releases the locking pin.
- Page 6 Lift fascia out of enclosure. Insert cable (supplied with Apple iPad) allowing 10cm to remain “free” at charge/sync connector end by gently pressing into retaining moulding. Feed USB end of charge/ sync cable through middle of enclosure, below pin, so it just protrudes from bottom Plug cable into USB Power of support column.
- Page 7 Plug charge/sync cable into iPad and place inside enclosure, gently press all four corners of iPad down into mouldings to hold. NB – If you are not using cable management for charging, unlock the iPad enclosure by inserting key into security lock and rotate ‘QUARTER TURN ONLY’ clockwise or counterclockwise through 90 degrees which releases the locking pin.
- Page 8 Replace fascia and depress lock button to secure enclosure.
Need help?
Do you have a question about the IPDTBL and is the answer not in the manual?
Questions and answers