Advertisement
Available languages
Available languages
14
www.raider.bg
the knife with a wrench 36. Before inserting a new blade or after you have banished the old
one, make sure the blade is positioned correctly and both pins are put into holes in the knife.
Beware! One pin is irregularly cylindrical shape and can only come into the corresponding
hole of the knife. This ensures the installation of the only knife in the correct position. Then
tighten the bolt again and make sure that no gaps and the knife is installed correctly. Use only
suitable for grass cutters.
6.3. Always clean the main hair when I leave for longer storage. Especially in winter. Grease
a knife with oil to protect it from rust. To save space, you can disassemble the top of the hair
on the bottom.
7. Faults and correct them.
The table below shows symptoms of failure and how you can help if your hair is no longer
working properly. If you can not find and fix the problem by following the instructions in the
table, contact an authorized service Ryder. Warning: before removal of damaged hair and stop
it off from the mains.
Faults
Mower does not
start to work
The engine is on,
but the knife does
not rotate.
Engine is turned
off suddenly.
Unusual noise.
Strong vibrations.
Unequal mowing.
Engine work
hard and reduce
turnovers.
Removal
Power cable is not connected or
damaged
Mower is in a tall grass.
It is possible that the mower is fuzzy
and the blade is blocked.
Plug is withdrawn
Bolt is loose or the blade connections
between fasteners.
Distorted and damaged knife.
The grass is very high.
The knife is blunt.
It is possible that the mower is fuzzy
and blocked
The sword can be installed incorrectly. . Check.
Reasons
Check cable. If necessary,
replace it.
Upon initial release always
put the mower in the grass
Disconnect the plug and
check it. Put on your
protective gloves and clean
the knife and release
Check cable. Make sure it
is well enshrined and plug
it again.
Fasten the parts.
Immediately stop the mower
and replace the knife in a
specialized service.
Increase mowing height.
Replace or tipped knife.
Look underneath the mower
and clean it. Work always
with protective gloves.
Advertisement
