Advertisement
Available languages
Available languages
The optimal length of the shaft angle of 35 ° thanks to the bevel
gear cutting easier in a plane parallel to the ground.
3.5. Adjust the belt the most comfortable position at work. Adjust the belt so that the cutting
equipment to be parallel to the ground.
4. Starting the engine.
4.1. Plug the extension cord to plug. Then plug the other end of the bridge contact 230 V.
Make sure the cord is away from the mower blade and the area to begin to mow.
4.2. Turn on the electric hair grass by pressing a button the seat and press the lever of the
switch to the handle. Release the safety button.
4.3. Electric hair grass off by running the lever of the switch and you wait for the knife to
stop spinning!
Do not switch the mower immediately after taking it off.
5. Practical tips:
5.1. Observe local regulations for the time of day during which you can use the machine
outdoors. In some countries it is forbidden mowing in the morning before 08.00 hours, after
lunch between 2:00 p.m. to 16:00 hours and after 22:00 at night to protect citizens from
unwanted noise.
5.2. Often lawns are composed of different varieties of grasses. If you frequent mowing will
enhance the growth of these varieties form dense turf and strong roots. If you mow your lawn
frequently will strengthen and improve the development of high-growing grasses and weeds.
The normal height of the grass is about 4-5 cm. It is also to plan the frequency of mowing, with
a cut to reduce at most one third of the total height of grass. Do not mow the grass at lower
than 4 cm, because eventually it will be drought damage.
5.3. Mow the lowest height (28 mm) only if your lawn area is very flat, expect heavy rains
or will leave.
5.4. The average height of cut (43 mm) is best when the interval between the previous and
next mowing are not lengthy.
5.5. Cutting height of (58 mm) is suitable for the first mowing of the season and when there
is drought.
5.6. When working in very difficult conditions to be careful not overload the motor. Overload
the speed of the motor falls and its sound is changing. In this case, stop, release the lever
to include (1) and set at a height of mowing. Otherwise, productivity will be reduced and the
machine may be damaged.
5.7. When mowing close to edges, careful not to pinch the hair with foreign objects.
5.8. Cutting performance depends on the density, humidity, grass length and the height
of cut. Cutting performance decreases with frequent switching of the hair during cutting. To
optimize the performance of mowing recommended more frequent mowing, increasing the
height of cut and work with moderate speed.
6. Service, maintenance and storage.
WARNING! Always disconnect the plug from the wall outlet before making activities related
to maintenance or cleaning!
Once the machine is off, the blade continues to rotate for a while coasting! Before you start
working on your hair, wait for the rotation of the motor and the blade to stop completely!
Never try to stop the rotation of the knife!
When you need to operate in proximity to the knife, work gloves always!
Perform maintenance procedures regularly to ensure durable and reliable use of the hair.
Check it periodically for visible defects such as loose or damaged knife and loose screw
connections. Make sure lids and protective equipment are intact and are installed correctly.
6.1. Cleaning.
Easiest to clean your hair immediately after mowing. After working carefully clean the
machine with a soft brush and cloth. Do not use water and / or solvents and detergents.
Remove any bits of grass, especially from the vents. Place the machine on its side and clean
the blade area. Work Always wear gloves! Remove particles stuck firmly to wood or plastic
block.
6.2. Sharpening or replacement of the cutting edge.
Replace dull or damaged blades. Blade is removed by bolt unscrewed the main center of
13
Advertisement
