Table of Contents
Advertisement
1. Remove the screw located above the window switches. Then with a panel
tool, pop off the entire instrument panel trim from its retaining clips.
(Figure A & B)
2. Disconnect the wiring harness connector, then unclip and remove the
Media Hub from the backside of the panel. (Figure C)
3. Snap in the AXUSB-RAM1 and route the harness to the radio location.
Note: A Micro HDMI to HDMI cable is necessary if HDMI input is desired.
(sold separately)
Attention! USB Type-C adapter may be necessary. This is supplied with the
Pioneer Radio.
Note: Refer to the Pioneer Radio installation manual.
4. Once the AXUSB-RAM1 is installed, this portion of the dash can be
reassembled.
AXUSB-RAM1 INSTALLATION
(Figure A)
(Figure C)
(Figure B)
REV. 6/18/21 INSTAXPIO-JT1
5
Advertisement
Table of Contents
