Table of Contents
Advertisement
INTERFACE COMPONENTS
• AX-GMCL2-SWC interface • AX-GMCL2-SWC harness
• 16-pin harness with stripped leads • 4-pin harness with stripped leads
• Female 3.5mm connector with stripped leads
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape • Connectors (example: butt-connectors, bell caps, etc.) • Small flat-blade screwdriver
APPLICATIONS
See inside front cover
AxxessInterfaces.com
GM Data Interface with SWC
INTERFACE FEATURES
• Provides accessory power
• Retains the factory AUX-IN jack
(12-volt 10-amp)
• Retains RSE (rear seat
• Retains R.A.P. (retained
accessory power)
• Retains SAT (satellite radio)
• Provides NAV outputs (parking
• Can be used in non-amplified,
brake, reverse, speed sense)
• Retains chimes
• Retains audio controls on the
• Retains balance and fade
steering wheel
• Retains OnStar / OE Bluetooth
• Micro "B" USB updatable
• Adjustable OnStar level
* The RSE must be activated by the factory radio
© COPYRIGHT 2018 METRA ELECTRONICS CORPORATION
AX-GMCL2-SWC
I N S TA L L AT I O N I N S T R U C T I O N S
2000-2013
TABLE OF CONTENTS
Connections to be made ................................... 3-6
- For models without an amplifier .......................3
- For models with an analog amplifier ................4
- For models with a digital amplifier ...................5
entertainment) *
Installing the AX-GMCL2-SWC ...............................6
Programming the AX-GMCL2-SWC .........................6-7
or analog/digital amplified
Adjusting the AX-GMCL2-SWC ...............................8
models
Extra features .....................................................8-9
Steering wheel control settings ......................9-12
(excludes digital amplified
- L.E.D. feedback ....................................................9
models)
- Changing radio type ......................................... 10
Troubleshooting ....................................................12
CAUTION!
controls panels, and especially air bag indicator
lights must be connected before cycling the
ignition. Also, do not remove the factory radio
with the key in the on position, or while the
vehicle is running.
All accessories, switches, climate
REV. 7/24/18 INSTAX-GMCL2-SWC
Advertisement
Table of Contents
Related Manuals for Axxess AX-GMCL2-SWC
Summary of Contents for Axxess AX-GMCL2-SWC
-
Page 1: Table Of Contents
- Changing radio type ......... 10 • Micro “B” USB updatable • Adjustable OnStar level • AX-GMCL2-SWC interface • AX-GMCL2-SWC harness - Remapping the steering wheel control buttons ...10 • 16-pin harness with stripped leads • 4-pin harness with stripped leads... - Page 2 APPLICATIONS BUICK CHEVROLET (CONT) OLDSMOBILE Century 2004-2005 Express 2003-2007 Canyon 2004-2012 Alero 2001-2004 Impala 2000-2005 LaCrosse 2005-2009 Envoy * 2002-2004 Bravada * 2002-2004 Kodiak C4500-C8500 2003-2009 Rainier * 2004 Envoy 2005-2009 Intrigue 2002 Malibu 2001-2003 Rainier 2005-2007 Savana 2003-2007 PONTIAC Malibu Classic 2004-2005 Regal...
-
Page 3: Connections To Be Made
• Connect the Blue/Pink wire to the VSS/speed sense wire. sense wire. Note: There are (2) speed sense wires. If the Blue/Pink wire on the AX-GMCL2-SWC harness is • Connect the Red and White RCA jacks to the audio AUX-IN jacks of the aftermarket radio. -
Page 4: For Models With An Analog Amplifier
If you are unsure if your vehicle is factory Note: There are (2) speed sense wires. If the Blue/Pink wire on the AX-GMCL2-SWC harness is populated on the factory side, use that wire instead. -
Page 5: For Models With A Digital Amplifier
If you are unsure if your vehicle is factory ampli- Note: There are (2) speed sense wires. If the Blue/Pink wire on the AX-GMCL2-SWC harness fied or not, please contact your local dealership. -
Page 6: Mm Jack Steering Wheel Control Retention
2001-2004 Relay 2005-2007 • For all other radios: Connect the 3.5mm jack from the AX-GMCL2-SWC into the jack on the aftermarket radio designated for an external steering wheel control interface. Please refer to the aftermarket radios Intrigue 2002 manual if in doubt as to where the 3.5mm jack goes to. - Page 7 Note: The L.E.D. will turn on solid Green for a moment, and then turn off under normal operation 10. If the interface fails to function, refer to Resetting the AX-GMCL2-SWC, then resume from step 7. after the key has been cycled.
-
Page 8: Adjusting The Ax-Gmcl2-Swc
• If your vehicle comes equipped with AUX-IN, rear seat entertainment, or satellite radio, the • With the vehicle and radio turned on, turn the volume up 3/4 of the way. AX-GMCL2-SWC can retain these features. • With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio •... -
Page 9: Steering Wheel Control Settings
SOURCE button is pressed for 2 seconds the source will change. The sequence of sources are * Note: If the AX-GMCL2-SWC flashes Red (7) times, and you do not have an Alpine radio connected SAT/RSE/AUX-IN. The AX-LCD will provide a visual confirmation of what source you are on. -
Page 10: Changing Radio Type
Mute. Follow the steps below to remap the steering wheel control buttons: programmed. 1. Ensure the AX-GMCL2-SWC is visible so you can see the L.E.D. flashes to confirm button 4. Press and hold the Volume-Up button until the L.E.D. goes solid, and then release. Repeat recognition. -
Page 11: Dual Assignment Instructions (Long Button Press)
The AX-GMCL2-SWC has the capability to assign (2) functions to a single button, except Volume- will tell the AX-GMCL2-SWC that this function is not available and it will move on to the next Up and Volume-Down. Follow the steps below to program the button(s) to your liking. -
Page 12: Troubleshooting
15. Fan-Up * 18. Temp-Down * 6. ATT/Mute * Not applicable in this application TROUBLESHOOTING Resetting the AX-GMCL2-SWC 1. The Blue reset button is located inside the interface, between the two connectors. The button is accessible outside the ® NOWLEDGE IS OWER Enhance your installation and fabrication skills by interface, no need to open the interface.