Hkcu-951 Sd Encoder Unit (Optional); Hkcu-953 Hd Frame Rate Converter Unit (Optional) - Sony HDCU-950 Operation Manual

Locations and Functions of Parts
HKCU-951 SD Encoder Unit
(Optional)
The HKCU-951 can be installed in the HDCU-950
expansion slot.
For information on installation, contact a Sony service or
sales representative.
Note
All the connectors function when the system is
operated at a 59.94-/50-Hz field frequency, but do not
operate when the system field frequency is 60 Hz.
Connector panel (VDA board)
For information on the internal EN board, see page 16(E).
EN
VBS
OUT
1 VBS OUT connector
Y/G
B-Y/B
2 Y/G, B–Y/B, and R–Y/R connectors
R-Y/R
1 VBS OUT (composite video signal output)
connector (BNC type)
Used for output of the video camera signal in analog
composite video format.
An internal setting enables the SD SDI OUT1 and
OUT2 connectors on the DIF board also to be used as
analog VBS outputs.
For information on the internal setting, consult a Sony
service or sales representative.
2 Y/G, B–Y/B, and R–Y/R (component video
signal output) connectors (BNC type)
Used for output of either Y, B–Y, R–Y component
video signals or G, B, R component video signals. The
type of signal is selected using switches on the EN
board. (Factory setting: G, B, R)
For information on the setting, contact a Sony service or
sales representative.
12(E)
HKCU-953 HD Frame Rate
Converter Unit (Optional)
The HKCU-953 may be installed in the slot for the
DIF board (SD output block)/internal RC board after
moving them to the expansion slot.
For information on installation, contact a Sony service or
sales representative.
Connector panel (SDI board)
For information on the internal FC board, see page 16(E).
FC
HD SDI
OUT 1
1 HD SDI OUT 1 and HD SDI OUT 2
HD SDI
connectors
OUT 2
FRAME
REF IN
2 FRAME REF IN and OUT
OUT
connectors
1 HD SDI OUT 1 and HD SDI OUT 2 (HD SDI
output 1 and 2) connectors (BNC type)
These connectors output the signals from the camera
as HD-SDI signals.
When the camera is operating in 24PsF mode, frame
conversion can be applied to input signals to provide
60i/50i signals from these connectors.
2 FRAME REF IN and OUT (frame reference
input and output) connectors (BNC type)
The IN connector is used to receive an HD tri-level
reference sync signal or SD reference sync signal
(black burst signal) for frame sequence lock between
camera control units. The signal supplied to the IN
connector is output from the OUT connector as-is.
When this unit is used as the master unit, the OUT
connector can be used as the frame sync pulse output
connector for pulldown.