Current SILENT TRAC Installation Manual page 8

3. ADJUST NUMBER OF CARRIERS AND ORIENT THE CARRIER ARMS
It may be necessary to add or remove carriers based on the curtain
size, fullness, and pleat spacing. To add or remove carriers, remove
the motor if it is installed. Then, loosen the hardstop screw and
slide it out of the track. See Figure 18.
Insert or remove carriers until the correct amount remain in the
track. Center draw applications may require adding or subtracting
carriers from each side.
For pleated drapery, insert or remove carriers until the correct
amount remain in the track. Center draw applications may require
adding or subtracting carriers from each side.
See Figures 19 & 20.
Based on where the window is located, there may be a desire to
reverse the orientation of an overlap carrier arm set. To reverse the
orientation, unscrew each arm from the master carriers, and swap
the two. See Figure 22.
Figure 18 - Remove hardstop
Figure 19 - Add or remove pin carriers
Figure 20 - Add or remove string carriers
Figure 22 - Reorient carrier arms if necessary
8