Current SILENT TRAC Installation Manual page 10

4. CONNECT THE SENSOR BOX (Optional)
Place and install the sensor box behind the drapery in a place where
the Pendant is still accessible and the sensors will still detect light
coming in from the window. See Figure 28.
Screw the wall plate into the desired location, using wall anchors
if necessary, then slide the sensor box over the plate until it sits
securely. See Figure 29.
On a single drapery, plug the motor into the Motor 1 slot. See
Figure 30.
On a dual drapery, plug the room side drapery into the Motor 1
slot and window side drapery into the Motor 2 slot. See Figure 32.
5. ATTACH THE DRAPERY
Snap or hook the drapery into each carrier starting with the master
carrier arm and ending with the hardstop and control end. For pin
ripple applications, hook the pins in one of two slots in the pin
ripple carrier to direct the drapery inward or outward. Generally,
pin ripple applications start and end with an inward orientation.
See Figure 33.
Figure 28 - Sensor box placement
Figure 29 - Attach sensor box to wall
Figure 30 - Motor plugged into slot
Figure 32 - Two motors plugged into slots
Figure 33 - Hook or snap drapery onto carriers
10