Current SILENT TRAC Installation Manual page 13

Power up by plugging the power input into the jack at the bottom
of the Pendant, and plugging the wall port into the desired outlet.
See Figure 43.
On units with power and control over CAT5, run the wire as
desired to the power and communication port. See Figure 44.
Plug the ethernet cable into the port at the bottom of the sensor box
housing or motor. See Figure 45.
Be sure to secure any excess cord, leaving no more than 8 inches unsecured, to reduce the risk of child strangulation.
2. SET DEFAULT OPEN AND CLOSE LIMITS
Now that your track is installed and power has been applied, the
track needs to find it's open and close limits. Pull down and release
the pendant to send the curtain to the full open position. Once the
curtain has reached this limit and had a hardstop, pull down and
release the pendant to send the curtain to the full close position and
let it set that hardstop. See Figure 46.
You can now move on to optional custom programming.
THIS IS THE END OF CEILING MOUNT INSTALLATION INSTRUCTIONS. PLEASE REFER TO OUR OTHER
INSTRUCTIONS FOR PROGRAMMING, ZIGBEE SET UP, AND FASCIA INSTALLATION. FOR ANY
QUESTIONS OR ASSISTANCE NEEDED IN INSTALLATION OR PROGRAMMING, PLEASE CONTACT US!
844-307-7435
support@currentproductscorp.com
13
Figure 43 - Plug input into bottom of Pendant and plug into wall outlet
Figure 44 - Run wire to power & communication port
Figure 45 - Plug ethernet cable into bottom of Sensor Box or Motor
Figure 46 - Pull & release Pendant to send drapery to full close position