Current SILENT TRAC Installation Manual page 4

Reference the bottom side of the wall bracket camlock protrusion
and align with the horizontal mark on the wall. See Figure 4.
Prior to mounting hardware, double check levelness and parallelism
with ceiling and floor. Check for levelness and height correctness. In
some cases it is more important aesthtically to maintain uniform
clearance of the drapery with the floor.
Slide the wall bracket over until the vertical pencil mark aligns with
the centerline of the wall bracket and the horizontal pencil mark
aligns with the bottom side of the wall bracket camlock protrusion.
Using appropriate mounting hardware and installation methods,
securely mark and screw the wall bracket to the wall. Do not over
tighten. There should be no movement between the bracket and
wall after installation.
Bracket spacing should never exceed 48". Always place a 2nd bracket
within 12" of the outer bracket on the motor end of the track. See
Figure 5.
Install subsequent single interior brackets using the recommended
spacing on the chart provided. See Table 1. Install subsequent dual
interior brackets using the recommended spacing on the chart
provided. See Table 2.
Table 1: Wall Mount Single Bracket Spacing Guidelines
6"
6"
6"
Bracket spacing based on drywall installation using wall anchors.
12" Every 16" - 48"
Every 16" - 48"
Every
12"
16" - 48"
Wall Bracket Camlock
Protrusion
Bottom Side
Figure 4 - Use bottom side of brackets as reference point for install
6"
Figure 5 - Install first bracket six inches in, then the second bracket
twelve inches in from the first
6"
12" 6"
12" 6"
4
Bottom
Side
height
12"
Curtain Weight Bracket Spacing
lb/ft inches
0.25 - 0.50 48
0.51 - 1.00 48
1.01 - 1.50 48
1.51 - 2.00 48
2.01 - 2.50 48
2.51 - 3.00 48
3.01 - 3.50 48
3.51 - 4.00 48
4.01 - 4.50 48
4.51 - 5.00 48
5.01 - 5.50 48
5.51 - 6.00 45
42
6.01-6.50
6.51-7.00 38
36
7.01-7.50
7.51-8.00 32