H3C SR6602-I AI Series Hardware Information page 27

LED
Power button/LED
Running status LED
(RUN)
System alarm LED
(ALM)
IRF LED (reserved)
Storage controller status
LED (RAID)
Management Ethernet
copper port LED (MGMT)
Status
Off
Flashing red (8 Hz)
Flashing red (1 Hz)
Flashing green (1 Hz)
Steady green
Flashing green (8 Hz)
Steady red
Off
Flashing green (8 Hz)
Steady green
Flashing green (1 Hz)
Flashing yellow (1 Hz)
Flashing yellow (8 Hz)
Steady yellow
Off
Steady red
Off
Flashing green (1 Hz)
Steady green
Yellow
Off
Steady green
Off
Steady green
Flashing green (3 Hz)
Steady yellow
Flashing yellow (3 Hz)
Off
3-2
Description
Mbps.
No link is present on the port.
A power cord is connected to the device or the
power button is pressed to start up the Comware
system.
The BIOS is starting up.
The BIOS has started and BootWare is starting up.
The Comware system is starting up or is operating
correctly.
The power button is pressed to power off the virtual
machine and Comware system.
The Comware system is shutting down.
The Comware system has been shut down.
The device is in BootWare stage.
The device is in Kernel stage, including Eshell
stage.
The Comware system is starting up or is operating
correctly.
The SDRAM has failed the self-test.
The extended BootWare segment does not exist.
The boot.bin file does not exist.
No power input, or exceptions have occurred.
An alarm has occurred on the system because of
excessive power, overtemperature, riser module
fan tray failure, or abnormal voltage.
No alarm has occurred on the system.
The device is the global active device in IRF mode.
The device is the standby device in IRF mode.
The device is in IRF mode but the establishment of
an IRF fabric has failed.
The device is in standalone mode.
The storage controller is present.
No storage controller is present.
A 1000 Mbps link is present on the port.
The port is sending or receiving data at 1000 Mbps.
A 100 Mbps link is present on the port.
The port is sending or receiving data at 100 Mbps.
No link is present on the port.