When Charging For The Optional Nimh; Life Battery - FUTABA T10PX Short Manual

Digital proportional r/c system
Hide thumbs Also See for T10PX:
Table of Contents

Advertisement

When Charging For The Optional NiMH/LiFe Battery
Charging A NiMH Battery
(Example: When using the HT5F1800B with the special charger)
1
Plug the transmitter cord of the special charger
into the charging jack on the rear of the trans-
mitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights.
Charging A LiFe Battery
(Example: When using the LiFe the special charger)
1
Plug the transmitter cord of the special charger
into the charging jack on the rear of the trans-
mitter.
2
Plug the charger into an AC outlet.
3
Check that the charging LED lights red.
4
When charging is completed, the charging LED
lights green. Disconnect the charge plug and
disconnect the AC plug of the charger.
With Balance Charger
(Example: When using the LiFe with an optional charger)
1
Remove the battery cover.
2
Disconnect the battery from the T10PX.
3
Balance charging cannot be done through the
transmitter. You must remove the LiFe battery to
do this charge.
LiFe battery is removed from the transmitter.
Warning
Make sure not to peel off the battery film, or make any scratch by a cutter knife or the sharp edges
of metal components.
Make sure not to soak or get the battery wet with water or seawater.
Make sure not to use a deformed or swollen battery.
There is a risk of explosion or fire, which is very dangerous.
The charging time when charging the HT5F1800B
battery with the optional special charger is approx-
imately 15 hours. However, when the battery has
not been used for some time, repeat charging 2 or
3 times to activate the battery.
Over current protection
The transmitter charging circuit is equipped with
an over current protection circuit (1.0A). If the bat-
tery is charged with a quick charger for other than
digital proportional R/C sets, it may not be fully
charged.
For Europe
Products for Europe cannot use NiMH / LiFe bat-
teries. This charge jack cannot be used.
The charging time when charging the FT2F-
2100BV2 battery with the optional special charger
is approximately 3 hours.
When the LiFe battery will not be used for a long
time, to prevent it from deteriorating we recom-
mend that it be kept in about the half capacity state
instead of fully charged. Also be careful that the
battery does not enter the over discharged state
due to self-discharge. Periodically (about every 3
months) charge the battery. In addition, always re-
move the battery from the model and store it in a
dry, cool place (15°C to 25°C).
Balance charging connector for LiFe battery charger.
Follow the directions of the optional LiFe chargers in use.
19

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

R404sbsP-cb10px

Table of Contents