FUTABA T10PX Short Manual page 26

6
Replace the steering unit bottom cover.
• Slide it outward and pull it out.
7
Install the rear unit to the connector on the opposite side of the transmitter body.
• Install slowly so that the wiring is not pinched.
8
Fit the rear unit to the t r a n s m i t t e r b o d y
with two M3x12 screws and one M2x6
screw.
9
Install the steering unit to the connector on the opposite side of the transmitter body.
• Install slowly so that the wiring is not pinched.
2 pin
1 0
Install the steering unit to the trans-
mitter using the two screws (M3x12
screw) supplied.
(Using a hex wrench.)
Rear unit
4 pin
Rear unit fixing screw
M3×12
Steering unit mounting screws
26
Steering unit bottom cover
M2×6
M3×12