Wheel & Trigger Tension Adjustment; Trigger Slide Adjustment - FUTABA T10PX Short Manual

Wheel & Trigger Tension Adjustment
Make this adjustment when you want to change the wheel or trigger spring's tension.
Adjustment
1
Using hex wrench, adjust the wheel
spring tension by turning the screw in-
side the adjusting hole.
- The spring is set to the weakest ten-
sion at the factory.
- When the adjusting screw is turned
clockwise, the spring tension increas-
es.
Note:
The adjustment range is up to 7 to 8 turns from the fully tightened (strongest) posi-
tion. If turned farther than this, the adjusting screw may fall out.

Trigger Slide Adjustment

The throttle trigger position can be moved forward and backward. Furthermore, the
angle of the throttle trigger operating direction can be changed in 3 steps.
Adjustment
1
Using a hex wrench, loosen the trigger slide mounting screw by turning it slightly coun-
terclockwise.
Always loosen this screw.
Note:
If the trigger slide screw is turned too
much, the screw may fall out.
2
Adjust the trigger slide position within the
marked range.
3
Retighten the mounting screw loosened at
step 1 and fasten the trigger slide.
Angle of the trigger operating direction
3°
3°
14
Wheel tension
adjusting screw
Adjust within the range
of the mark.
10 mm
Trigger tension
adjusting screw
Trigger mounting
screw
Note:
Be careful not
to damage the
case or wiring
as the trigger
unit is difficult
to move.