H3C S5130S-EI Series Installation Manual page 107

port and a 10/100/1000BASE-T autosensing Ethernet port. Only one of these two ports operates at a
time.
LEDs
System status LED
The system status LED shows the operating status of the switch.
Table4-13 System status LED description
LED mark
SYS
Management Ethernet port LED
Table4-14 Management Ethernet port LED description
LED mark
LINK/ACT
Power supply status LED
The S5130S-28F-EI and S5130S-52F-EI switches provide PWR1 and PWR2 LEDs on the front
panel to indicate the operating status of the power supplies.
Table4-15 Power supply status LED description
LED mark
PWR1/PWR2
Status
Steady yellow
Steady green
Flashing green (1 Hz)
Flashing red (3 Hz)
Off
Status Description
Steady green A link is present on the port.
Flashing green The port is sending or receiving data.
Off No link is present on the port.
Status Description
A power supply is installed in the power supply slot, and the
Steady green
power supply is outputting power correctly.
A power supply is installed in the power supply slot, but the
Steady yellow
power supply is faulty or not powered on.
Off No power supply is installed in the power supply slot.
Description
Boot ROM booting stage.
Linux kernel booting stage, or the switch has started up
correctly.
Software image loading and decompressing stage, or
software booting stage.
The switch has failed POST or the switch is faulty.
The switch is powered off or has not started up correctly.
4-57