Table of Contents
Advertisement
CASTILE INSERT
WARNING
Risk of Fire!
•
Damaged parts could impair
safe operation.
•
Do NOT install damaged, incomplete or
substitute components.
WARNING
Hearth & Home Technologies disclaims any
responsibility for, and the warranty will be
voided by, the following actions:
•
Installation and use of any damaged appliance.
•
Modification of the appliance.
•
Installation other than as instructed by Hearth &
Home Technologies.
•
Installation and/or use of any component part not
approved by Hearth & Home Technologies.
•
Operating appliance without fully assembling
all components.
•
Operating appliance without legs attached (if
supplied with appliance).
•
Do NOT Over fire
Or any such action that may cause a fire hazard.
B. Thermostat Wall Control Location
The thermostat wall control's location will have some affect
on the appliance's operation.
•
Maximum wire length from appliance is 100
feet (30.48m) with continuous non-spliced wire.
Recommended 20 gauge wire, solid copper.
•
When located close to the appliance, it may require a
slightly higher temperature setting to keep the rest of
the house comfortable.
•
When located in an adjacent room or on a different
floor level, you will notice higher temperatures near
the appliance.
6
C. Tools And Supplies Needed
Tools and building supplies normally required
for installation, unless installing into an existing
masonry fireplace:
-
Reciprocating Saw
-
Channel Locks
-
Hammer
-
Phillips Screwdriver
-
Tape Measure
-
Plumb Line
-
1/4" Self-Tapping Screws
-
Framing Material
-
Hi-temp Caulking Material
-
Gloves
-
Safety Glasses
-
Framing Square
-
Electric Drill & Bits (1/4")
-
Level
May also need:
Vent Support Straps
Venting Paint
D. Inspect Appliance and Components
•
Open the appliance and remove all the parts and
articles packed inside the Component Pack. Inspect all
the parts and glass for shipping damage.
•
Report to your dealer any parts damaged in shipment.
•
All labels have been removed from the glass door.
•
Plated surfaces have been wiped clean with a soft
cloth, if applicable.
•
Read all the instructions before starting the installation.
Follow these instructions carefully during the
installation to ensure maximum safety and benefit.
•
Follow pipe manufacturer instructions for installation
and air clearance requirements.
7022-801H
06/21
Advertisement
Table of Contents
