How To Remove Backplane - One Stop Systems PE3R Manual

7.4

How to Remove Backplane

NOTE
Maintenance of the equipment and removal of boards should be performed only by instructed person.
This section will show you how to remove the board from the expansion chassis.
1. Unplug the ATX 24-pin power cable from the board
2. Disconnect the On/Off and front led power assembly cables.
3. Unscrew the two jack-screws from the back of the unit.
4. Remove four screws from the backplane.
5. Slowly pull the board out from the expansion chassis.
Unplug the ATX 24-pin power cable from the board.
Disconnect the On/Off and front led power assembly cables.
PE3R 3-Slot PCI Expansion| 57
One Stop Systems