Install Pci Cards; Connect Cable To Expansion Unit; Connect Cable To Host Computer - One Stop Systems PE3R Manual

2.4

Install PCI cards

Install the PCI cards after verifying that the expansion chassis is working
2.5

Connect Cable to Expansion unit

Carefully route the cable to the rear side of the expansion chassis and attach it to the 68-pin connector, as shown below. Secure the cable with
the captive thumbscrews. It is important that the cable be attached securely to the connector.
2.6

Connect Cable to Host computer

Position the OSS expansion chassis so that the supplied PCI expansion cable will conveniently reach from the connector of the Host Card to the
connector on the back of the chassis.
Attach the PCI expansion cable to the 68-pin connector of the Host Interface card and secure it using the cable's captive thumbscrews.
PE3R 3-Slot PCI Expansion| 18
correctly, go to Chapter 4
One Stop Systems