Assembly & Installation - Harman Stove Company 44 Magnum Owner's Manual

Assembly and Installation
Fig.1
Rear Cover
Panels
Fire Brick
Flame Guide
Unpacking
Cut straps holding box together and remove box
from skid.
The 44 Magnum is bolted to the skid to prevent
movement during shipping.
To free the stove from the skid you must remove
the hold-down bolts in the rear of the pedestal base.
Installing rear cover panels
The rear cover panels are removed from the stove
to make it easier to get at the hold-down bolts.
The rear cover panels are packed inside the hop-
per and should be installed on the stove as shown. This
can be done before or after the stove is in place.
Firebrick
Install the firebrick vertically on the angle above
the burnpot. See Figure 2.
Flame Guide
Install the cast iron flame guide on top of the burn-
pot and make sure it is fully seated against the auger
opening. See Figure 2.The bottom of the flame guide is
marked 44ND.
Fig.2
5