Installation; Floor Protector - Harman Stove Company DVC500-C Manual

DO NOT INSTALL A FLUE
DAMPER IN THE EXHAUST
VENTING SYSTEM OF THIS UNIT
DO NOT CONNECT THIS UNIT
TO A CHIMNEY FLUE SERVING
ANOTHER
INSTALL VENT AT
CLEARANCES SPECIFIED BY
THE MANUFACTURER

INSTALLATION

fig. 6
fig. 7
APPLIANCE.
Tips On Installation
Before the position of unit can be decided a
few questions should be considered?
1. Can the unit be vented properly and installed
safely?
2. Will exhaust be vented where fumes can build
up or be drawn into lower levels of the structure
3. Will fumes and fly ash affect the exterior of the
structure or someone else's?
4. Are there any local regulations governing the
use and placement of the unit?
5. Are there any structural reasons why the unit
cannot be placed where you want?
6. How close is the electric outlet?

Floor Protector

This stove should be placed on a non-com-
bustible floor protector extending 16 inches to the
front, 8 inches to the sides, and 1 inch to the rear.
Straight Through Wall
1. When position of unit has been decided, use
measurements on Page 9. In this manual for the
hole through wall. Don't forget the thickness of
floor protector used.
2. Cut at least a 9" x 9" hole through wall.
3. Remove side doors and rear cover assembly (6
black screws, 5/16" socket or straight screw-
driver)
4. Place unit in front of the hole approximately
1/2" closer to the wall then the length of the
wall termination. (From outside of wall to back
of unit where termination bolts up)
5. Take wall terminators outside and slide into
hole until it mates to rear of unit. Go inside and
install bolts and tighten, making sure the gasket
is in place and the flue pipe section is level.
6. Reposition unit inward until the stainless steel
intake section comes against the outside surface.
NOTE: If the wall is over 8" thick you will need
a longer wall termination. The standard termina-
tion will provide 3" of wall clearance behind the
stove. Therefore a 5" thick wall will provide 6"
of clearance.
8