Assembly & Installation - Harman Stove Company XXV Installation & Operating Manual

Fuel should be stored in a cool dry place, well away from
the room heater. do not store fuel within the installation
clearance area or the space required for loading and/or
ash removal.
dO n Ot uS e M a k eSh iFt Par tS O r O th e r
cOMPrOMiSeS when inStalling thiS aPPliance.
dO nOt inStall a Flue daMPer in the eXhauSt
Venting SYSteM OF thiS unit.
dO nOt cOnnect thiS unit tO a chiMneY Flue
SerVing anOther aPPliance.
cautiOn: dO nOt cOnnect tO anY air diStributiOn
duct Or SYSteM.
warning
keeP Viewing and aSh reMOVal dOOrS and
hOPPer lid tightlY clOSed during OPeratiOn.
cautiOn
hOt while in OPeratiOn. keeP children,
clOthing and Furniture awaY. cOntact MaY
cauSe Skin burnS.
Flame guide
Install the cast iron flame
guide on top of the burn
pot. Make sure that the
flame guide is fully seated
on the vertical sides of the
burn pot and that the back
of the guide rests against
the burn pot mounting
flange.
Install the venting only at the clearances specified by
the venting manufacturer. Some brands of pellet venting
require a 3" clearance to combustibles, while other brands
may require only one inch.
nOte: all Packaging & ShiPPing MaterialS
MuSt be reMOVed FrOM the StOVe beFOre
OPerating.
5
XXV Pellet Stove
iMPOrtant nOteS
assembly and installation
cautiOn
keeP cOMbuStible MaterialS (Such aS graSS,
leaVeS, etc.) at leaSt 3 Feet awaY FrOM the
Flue Outlet On the OutSide OF the building.
dO nOt burn garbage Or FlaMMable FluidS
Such aS gaSOline, naPtha Or engine Oil.
Due to high temperatures, the stove should be placed out
of traffic and away from furniture and draperies.
children and adults should be alerted to the hazards of
high surface temperatures and should stay away to avoid
burns to skin and/or clothing.
Young children should be carefully supervised when they
are in the same room as the stove.
Clothing and other flammable materials should not be
placed on or near this unit.
installation and repair of this harman® stove should
be done by a qualified service person. We recommend
that the stove be inspected before use and at least
annually by a qualified service person. Periodic cleaning
is required throughout the heating season and at the
end of each winter for the stove to work efficiently. See
cleaning instructions.
Figure 1
The power cord is tucked inside the left rear cover panel. To remove
cord, Loosen the two 5/16" hex heads and slide the panel outward.
3-90-00684R22_04/13